Ideally you will need 54 inches of horizontal space to mount one bar on top and another bar below so the holding prongs are off center. The hanger does not come with mounting screws so you will need #10 by 2 1/2 in wood screws.
© Copyright 2018 Harbor Freight Tools. All Rights Reserved. MATERIAL AND PHOTOS ON THIS SITE ARE THE COPYRIGHTED PROPERTY OF HARBOR FREIGHT TOOLS AND MAY NOT BE USED WITHOUT THE PRIOR WRITTEN PERMISSION OF HARBOR FREIGHT TOOLS.
Grainger Safety Services Grainger Facility Services Grainger Energy Services Grainger Lighting Solutions Grainger Midstream Utility Rebate Incentive After-Hours Emergency Service Grainger KeepStock Inventory Management Grainger Consulting Services
Just to cut to the chase, if your casters won’t fit no matter how hard you push or how much you smack them with a mallet, it’s because the holes have been warped (due to a poor molding process in the factory, getting squished in transport, or melting or something). You absolutely can fix this by re-drilling those existing caster holes with a 7/16th drill bit, and the problem will be solved forever.
It is sturdy and holds a lot but need to make sure how you put those tools in it to keep the balance. So this time, I made it tilt a bit towards to the back by putting a piece of ply wood in the front so it will have better balance…and I would pay more attention when I put the tools back into this organizer next time.
Shake your box all you like, these no-slip rails won’t move an inch! High-grip rubberized material eliminates the need for expensive magnets. Perfect fit for all drawers, even the most shallow. Holds 14 screwdrivers. Comes with two 15-1/2” rails for standard toolbox drawers. Trims down easily for custom fit if needed. Available in red.
I bought this because I have an Arrow steel shed. I thought it would somehow be easier to install than other tool storage solutions available just about anywhere. Rather than connect to any of the supports in the shed, it’s quite literally a matter of drilling holes in the wall and putting in some sheet metal screws. It doesn’t even include the plastic washers you should be using for any hardware on the outside of the shed- you’re on your own there. It works, but a $15 solution at my local hardware store wouldn’t have been any different to install in my Arrow metal shed than this.
So, knowing the hanger is plastic, it does what it’s supposed to. I bought it when it was on sale for a fraction of the usual price. At the higher price it would have been a “no way”. You get what you pay for. The tool rack and a small cardboard retail pegboard hanger. There are NO instructions of any kind and no fastening devices like screws. Since it was actually designed to be used with Suncast sheds I was hoping it would snap or somehow fit into premade notches formed into the shed but no such luck. Since you have to screw it to the plastic walls of the shed it is no better of a rack than anything you would buy at the hardware store.
Tools left on the ground in your workspace can be a tripping hazard waiting to happen. It’s important to have your tools in a safe place that’s out of harm’s way from yourself, other coworkers, or guests to your space. Don’t take the risk of leaving your tools on the ground for people to trip over, walk on, or injure themselves any longer.
A great option for storing and organizing all of your garden tools. This product works indoors and outdoors with a no-slide guarantee. Install is simple and has the ability to hold up to 50 pounds. The best thing about this product is the fact it is compact. A lot of garden organizers today require a lot of space, or be hanged in a specific place. The Berry Ave Broom Holder and Garden Tool Organizer takes care of this problem with it’s genius, small design.
This product is not as advertised. The plastic is very flimsy and poor quality. The hooks can’t hold heavy tools and objects. Should have gone for the one made out of metal instead of plastic. I don’t expect this to last very long. It’s not worth the price.
Select items that are not included in ShippingPass will ship for free but with value shipping. Look for items sold by Walmart.com and marked with FREE shipping. You will also see this noted in checkout.
Performance Advantage Company offers tool hangers that are easy to use and hang on walls in any part of your workspace or garage that needs more organization. This durable tool hanging product is perfect for hanging shovels, brooms, and other T-shaped equipment. It also makes room for other storage and equipment in your workspace!
Spring Cleaning is nigh! I see an influx of many new **likes**, and friends. I think we may need to spoof up our facebook page. I wait for my secret dust mitts to arrive- I intend to revolutionize blind cleaning in these next 2 weeks! For ALL OF HUMANITY! and document it. Live. That’s right. finally , busting into some iPhone skills. Finally. soon, my phone will put things on icloud and free up lots of space for documentation!
ABSOLUTELY GREAT — GET YOUR TOOLS OFF THE FLOOR AND USE OTHERWISE WASTED SPACE. NICE QUALITY AND A GREAT ADDITION TO YOUR SHEDS! I HAVE PURCHASED MORE THAN A DOZEN AND HAVE INSTALLED THEM IN ALL SHEDS BECAUSE THEY ARE USEFUL FOR HANGING ANYTHING TO KEEP IT OFF THE GROUND. THESE HANGES ARE STRONG ENOUGH AND EASY TO INSTALL.
These seem like they’ll work ok BUT the spacing of the two screw holes on either side are practically the same width as a standard 2 by 4 that you probably want to attach them to in your walls. So if you have drywall covering the studs, you’ll likely have to get the screws perfectly spaced to hit the edges of your studs or otherwise I can see one screw being solidly in the stud and the other missing any wood and just being in the drywall; basically a tear waiting to happen. I’m waiting to install these in my drywalled garage once the weather warms up and I clean/organize my garage. But I foresee this issue of the screw holes being a problem.
The ShippingPass assortment is continually being optimized. Products are added and removed for lots of reasons, but the main reason is to show items that we’re 100% sure we can deliver within the promised timeline.
I used these hangers in my new garden shed. Other reviews had indicated that the screw holes did not line up well with studs and this would also limit how many I could install. What I did was to mount a 2X6 on the wall of my garden shed with lags into the studs then mounted the hangers every 2 feet and then mounted yet another 2X6 1 foot below the other 2X6 and then mounted the hangers so they were between the hangers above. This allowed me to hang all of my garden tools and still have some space left over for more tools. These are high quality hangers and I recommend them but forget mounting direct to studs.
After looking for a suitable replacement for this product with no success I opted for the next best option, a rework. I tossed the flimsy plastic casters. Used some old 2×4 scraps to add support to the plastic bottom, attached the bottom to plywood, and added suitable casters. Still somewhat flimsy but hopefully will work long enough to justify the expense.
This tool hanger meets my needs and then some. Very strong and will store most all garden tools. The only exceptions, that I have found, are tools that are straight with no wide implement on the end of the shaft.
According to the product description, it holds 40 tools but I’ve only got about 20-25 items in it, none of them overly heavy, and the rack bottom has sagged so low in the middle it won’t even roll along the floor any longer. The vertical risers have also bent. I looks as if I put an entire olympic free weight set into the rack, which I would EXPECT to distort it’s shape so much. But, just like the product pictures, I’ve only put light-weight poles, rods, and tools in the rack.
Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe’s reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.
Rubbermaid 30-Tool Corner Tool Rack (FG5A4700MICHR). Corner storage maximizes available space. Longer handle tool storage organizes 30 tools. Plastic construction is sturdy but lightweight and easy to move even when loaded. Easy to assemble without tools. The large, solid base provides stability, so it won’t tip over even with large tools stored in it. Integrated holes in the top let you anchor the storage tower to the wall. Overall dimensions: 32 inches by 18 inches by 20 inches. For nearly 80 years, Rubbermaid has represented innovative, high-quality products that help simplify life. Recognized as a “Brand of the Century” for its impact on the American way of life.
Magic Broom is proud to have two locations, one in Waldorf, Maryland and the other in Lexington Park, Maryland. We provide services to Charles, Calvert, St. Mary’s, Prince George’s, and Lower Anne Arundel counties. Our service area extends north to Tracy’s Landing, south to Scotland, east to Chesapeake Beach, and west to Nanjemoy. To find out if you’re within our service area, please refer to our detailed Service Area page.
Founded in 1977, Harbor Freight Tools is the leading discount tool retailer in the U.S. selling great quality tools at ridiculously low prices in over 850 stores nationwide and on its website www.harborfreight.com. Harbor Freight Tools stocks over 7,000 items in categories including automotive, air and power tools, shop equipment and hand tools. With a commitment to quality and a lifetime guarantee on all hand tools, Harbor Freight Tools is a favorite of automotive and truck repair shops, government agencies, schools, manufacturers, contractors and tool enthusiasts who want top-quality and great selection and value. The results speak for themselves – with over 40 million customers and thousands of people switching to Harbor Freight Tools every day.
To see if ShippingPass is right for you, try a 30-day free trial. Also, with ShippingPass, there is no need to worry about commitment. If you decide you want to discontinue the service, you can cancel your subscription at any time. No matter what your shipping needs, Walmart’s got you covered. Sign up for ShippingPass so you can shop more, save money and live better.
This wall hook rack is designed with 5 This wall hook rack is designed with 5 double hooks made of iron on a rectangular mango wood wall mount offering convenient hanging storage options for homes and offices. Its distressed paint finish brings rustic vibes to interior design themes. The turquoise and natural brown colors of this wall hook …  More + Product Details Close
With these simple and functional stainless steel S hooks. works great for hanging your kitchen tools,such as pans, pots, spatulas, coffee mugs, hand towels, potholder, spoons. 12 X Flat S Hooks. Perfe…
I am replacing the Suncast 4 foot tool hanger with one just like it that had pulled away from the wall and split in two. I guess I had a little too much weight on it. It’s too bad that this product is not made of metal. It would be much better if it were. It’s made of heavy plastic. That’s why I gave it 3 stars. Also, if you put more than one tool on each handle holder they tend to slid off. I drilled a two inch screw into the top edge of each handle near the end to stop the slipping off problem. I would not have bought this product again except that it is the perfect size for my garage space. The first one lasted around 10 years, so that’s not too bad. If I can get another 10 years service out of this replacement tool hanger then I’ll be satisfied before I have to replace it again. It’s not the best product out there, but if you don’t put too much weight on it it should last a long time. Also, it is helpful if you can find a large metal washer and put it between the screw you put into the wall and on top of the plastic. This gives it more strength and makes it less likely to pull away from the wall.
推式扫帚-商业拖把桶

We have earned a reputation for providing the highest level of house cleaning services in the Memphis, TN area. We have experience in dealing with all size properties. We also have experience dealing with new and old properties. No matter what type of house or property you have we can provide you with a unique service, that will cover all your expectations. Our mission is turn all your days into extraordinary days.